30
2. You can also disengage the swingbolt using the mechanical override key by
performing the following operation: insert the mechanical key in the lock
override cylinder’s vertical slit and turn it clockwise to the horizontal position.
With the key still in this horizontal position, turn the thumbturn clockwise
to disengage the swingbolt which will fully retract down and will stay retract-
ed. Let go off the thumbturn so that it will revert back to its normal horizon-
tal (home) position. Turn the key back to its vertical position and remove it
from the lock cylinder.
3. To Engage (project swingbolt): This procedure is almost the same as in Step
1 above. Enter a valid PIN and the lock will flash the green LED indicating that
you are a valid user and you are allowed to engage the swingbolt to lock
back. Turn the thumbturn on the lock front housing clockwise and hold
. The
swingbolt will revert back up to its locked, horizontal (home) position. Let go
off the thumbturn so that it will also revert back to its normal horizontal
(home) position.
Warning: Ensure that you relock the door (engage the swingbolt) when not
needed; otherwise the lock will stay unlocked permanently compromising
security.
4. You can also engage the swingbolt using the mechanical override key by
performing the following operation and the procedure is almost the same as
in Step 2. above. Insert the mechanical key in the lock override cylinder’s
vertical slit and turn it clockwise
to the horizontal position. With the key
still in this horizontal position, turn the thumbturn clockwise
to engage the
swingbolt which will revert back up to its locked, horizontal (home) position.
Let go off the thumbturn so that it will also revert back to its normal horizontal
(home) position. Turn the key back to its vertical position and remove it from
the lock cylinder.
To Next Page
Loading...
Need help?
General
