Kaco blueplanet 3.0 NX1 M2 - 4 Technical Data; 4.1 Electrical Data

KACO blueplanet 3.0 NX1 M2 KACO blueplanet 3.7 NX1 M2 KACO blueplanet 4.0 NX1 M2 KACO blueplanet 5.0 NX1 M2 Page 8
Fig. 19 connect to smart meter
8 Insert the other end cable conductors into the slots of smart meter and tighten them.
Screwdriver type: PH0, torque: 0.7Nm.
NOTE
The smart meter should support the MODBUS protocol with a baud rate of 9600 and address set 1
2.2 Inverter parameters settings
2.2.1 Connect to inverter
Connect to the Wi-Fi stick with the tool app.
 Enter the “Inverter list”.
1 Enter the “Monitor Device Details” page
2 Click the “Inverter List” item and enter the “Inverter List” page to connect to the inverter.
3.Click the inverter serial number
.
» Proceed with inverter parameters settings.
Fig. 20: Connect to inverter