Kaiweets ST100 - Page 5

light on.
® When the strong electric field signal is
detected, it will display “—H"; the
buzzer will sound quickly and the red
light on.
2. Smart (AUTO) measurement
In this mode, DC voltage, AC voltage,
resistance, continuity can be measured,
and the meter can automatically identify
the measurement signal.
1) Press the “ (1) " key to power on.
Then press the “FUNC” key to select
“AUTO" gear, the meter displays
“Auk o’ to enter the smart testing
mode.
2) Insert the red probe into “INPUT"
jack and the black probe into the
“COM " jack.
3) Contact the probe with both ends of
the measured subject or resistance
in parallel, and the meter will
automatically recognize the
measured signal.
4) When measuring the resistance, if
the resistance value is < about 50 @,
the buzzer will sound.
5) Read the results from the display.
5