Printing Data
Press the SEND/PRINT button for 1 second to start the data transfer from
the analyser to the infa-red printer. The analyser displays a series of bars
until the transfer is completed. Press the button for 1 second again to
abort the transfer.
Make sure the printer is switched on, ready to accept data and the infa-
red receiver is inline with the emitter of the analyser (on top of the
analyser).
Storing Data
Press and hold the SEND/PRINT button for approximately 2 seconds.
The top line of the display briefly displays the log number.
Note:
The store function is inhibited in normal operation if the pump is
switched off.
7. USING / / BUTTONS
The function buttons with the symbols / / below are
used to navigate through the menu when the rotary dial is in the menu
position.
To Next Page
Loading...
