Page 21
ROOM CO display
→
CO readings are recorded every minute for
up to 30 minutes.
→
Real time CO reading (ppm).
→
Test 00 = initial CO test in series.
Test 30 = maximum of 30 tests in series.
→
The CO test series is automatically stored in
the memory as a log number.
The user can stop the Room CO test at any time by pressing / .
If not stopped earlier, the Room CO test will automatically end after the designated
time.
The CO test series is automatically stored in the memory as a log number.
When completed the log can be printed immediately by pressing .
Viewing / printing a logged Room CO test
Select MENU / REPORT / ROOM CO / VIEW
When LEDs are not flashing
Use the / keys to change line.
Press to cause the LEDs on that line to flash.
With the LEDs flashing, press / to allow the parameter on that line to be
changed.
Press to select that change.
The LEDs stop flashing and /
Use
/ to change the line again.
To Next Page
Loading...
