Kane AUTOplus 4-2 - Page 31

AUTOplus manual
Page 31
Remove the probe from the vehicle exhaust - TAKE CARE ! THE PROBE
WILL BE HOT - and allow it to cool naturally. Do not immerse the probe in
water as this will be drawn into the analyzer and damage the pump and
sensors.
Once the probe is removed from the exhaust allow the readings to return to zero
and press the analyzer will count down from 30 to switch off.
OFF 30
MENU TO ESCAPE
12.52.30 am
26/04/12
If you have not finished but press by mistake, you can press to
return to normal operation and not switch OFF.
TIP: It’s a good idea to empty the water trap after testing so that the risk of
water getting on to the particle filter or into the analyzer is minimized.