Kane AUTOplus 4-2 - Automatic Zero Calibration

AUTOplus manual
Page 9
4.2 Automatic Zero Calibration
During this sequence the analyzer pumps fresh air into the sensors to allow
them to zero and the oxygen sensor to be set to 20.9 %.
After switch-on the analyzer will briefly display information:
AUTOplus
SW V1.01
Bluetooth
Auto 4 or Auto 5 indicates 4 or 5 gas version
SW is the software version
Bluetooth indicates Bluetooth fitted and enabled
(If the charger is connected and is pressed the display will show