2. SAFETY WARNING
This analyzer extracts combustion gases that may be toxic in relatively low
concentrations. These gases are exhausted from the top of the analyzer. This
analyzer must only be used in well-ventilated locations. It must only be used by
trained and competent persons after due consideration of all the potential
hazards.
Protection Against Electric Shock (in accordance with EN 61010-1 : 2010)
This analyzer is designated as Class III equipment and should only be
connected to SELV circuits.
The battery charger is designated as:
Class II equipment
Installation category II
Pollution degree 2
Indoor use only
Altitude to 2000m
Ambient temperature 0°C-40°C
Maximum relative humidity 80%
Mains supply fluctuations not to exceed 10% of the nominal voltage.
To Next Page
Loading...
Need help?
General
