KanexPro EXT-HDBTKVM100 - 2 Panel Description; Transmitter (EXT-HDBTKVM100 T)

HDBaseT 2.0 KVM Extender Set
1
2. Panel Description
2.1 Transmitter (EXT-HDBTKVM100T)
No.
Name
Description
①
Indicators
Power:
" OFF: No power
" RED: DC power present
ON: Working status indicator
" OFF: Not operational
" Blinking GREEN: Normal operation
LINK: HDBT Link status indicator
" OFF: No Link
" GREEN: Link successful
" Blinking GREEN: Link problem
HDCP: HDCP compliant indicator
$ OFF: No HDMI traffic (no picture)
$ GREEN: Traffic with HDCP
$ Blinking GREEN: Traffic without HDCP
②
Transmission
Mode Switcher
Activate 100m/ 150m-transmission mode.
" 100m mode: 4Kx2K@60Hz and 1080p signals can be
transmitted up to 100m
" 150m modes: 1080p signal can be transmitted up to 150m,
but will not support 4K signals.
Note: After setting switch position, the mode will not take effect
until units are restarted. Please set both ends identical.
③
FW
Micro USB port, used for firmware update.
Firmware update needs auxiliary equipment, please contact
DC 12V
Tx Rx
RS232HDBT OU THDMI IN USB OUT
FW100m / 150m
MODEON LINK HDCP
1
4
5
6
7
8
2 3
Front
Rear