Name: Kanguru KCLONE-4NVME
Brand: Kanguru
Rating: 4 (1 reviews)

To Next Page

To Previous Page

4. Press down on the top of the drive so that it lies parallel with the duplicator. There should be a

few mm space between the drive and the duplicator.

5. Slide the Drive Locking Pin foward until it fits into the notch located at the rear of the NVMe

drive.

WARNING! It is OK to connect and disconnect Master or Target drives while the KanguruClone is

powered on. However, do NOT connect or disconnect drives while any operation is running.

General Operation

Questions and Answers:

Need help?

Do you have a question about the Kanguru KCLONE-4NVME and is the answer not in the manual?

Kanguru KCLONE-4NVME Specifications

General