17
6.4 Erase Settings
• Methods - Configure a CUSTOM erase methodology. Multiple methods can be selected.
○ Write 0: Overwrite all addressable locations with binary zeroes. Enabled by default.
○ Write 1: Overwrite all addressable locations with binary ones. Disabled by default.
○ Write Random Pattern: Overwrite all addressable locations with a random bit pattern.
disabled by default.
• After Erase
○ Compare: Automatically compare data on connected drives after an erase is performed.
Disabled by default.
○ Verify: Verify the final overwrite pass after an erase is performed. Disabled by default.
• Cycles - Select the number of cycles an erase function is performed. Default: 1
6.5 Option Settings
• Capacity Check - Check that the capacity of Target drives are at least equal to or larger in
capacity as the Master drive. Enabled by default.
• Quick Erase - Zero the partition table on Target drives. Disabled by default.
• Erase Source Port - Allow the drive connected at the Source position to be erased. Disabled by
default.
• Save Mode - Save the current setting configuration.
Settings
To Next Page
Loading...
