8
2.3 Calibrating the Touchscreen
One of the main features of the KanguruClone 4 M.2 NVMe Duplicator is the touchscreen user
interface. If you are having issues with the accuracy of the touchscreen inputs (e.g. unable to access
items to the edge of screen) your touchscreen may require re -calibration.
To calibrate the touchscreen:
1. Power on the duplicator.
2. Wait for the boot screen that displays the Kanguru Logo and the device firmware and Mac
address.
When this screen appears, tap the center of the touchscreen.
3. The calibration screen appears. Follow the onscreen instructions to re-calibrate the touchscreen.
If you are still having problems with touchscreen accuracy, you can also use a stylus to tap the screen.
General Operation
To Next Page
Loading...
Need help?
General
