63
The vehicle ignition was switched on. For safety reasons, the turntable moves into the park position.
This operates however only if the green ignition cable for the turntable is connected to the vehicle
ignition and the turntable is connected to the power supply! As long as voltage is present at the ignition,
the connection to the CAP will remain disabled. This means the CAP cannot be operated.
SPECIAL MESSAGES FROM THE TURNTABLE
The turntable antenna has reached the mechanical stop or is jammed! Check whether the turntable is
obstructed (e.g. by a branch).
If the turntable encounters an obstruction,
the CAP reverses 10°. This allows the
obstacle to be removed more easily.
The turntable motor temperature is in the critical range. Allow the turntable to stand for a few minutes
in its current position, until the turntable motor temperature has reduced.
To Next Page
Loading...