Kawai MP11SE - Reverb and EFX Parameters

40
EDIT Menu
EDIT Menu parameters (PIANO, E.PIANO, SUB)
1 Reverb
1. Type
6 types
This parameter selects the reverb type.
* For more information about reverb, please refer to page 22.
* This parameter is common for all three sound sections.
* This parameter is not stored to SOUND but to SETUP only.
2. Pre Delay
value: 0 ~ 200 ms
This parameter adjusts the delay time before the start of the
reverberation.
* For more information about reverb, please refer to page 22.
* This parameter is common for all three sound sections.
* This parameter is not stored to SOUND but to SETUP only.
3. Time value: 300 ms ~ 10.0 s
This parameter adjusts the reverb time.
* For more information about reverb, please refer to page 22.
* This parameter is common for all three sound sections.
* This parameter is not stored to SOUND but to SETUP only.
4. Depth value: 0 ~ 127
This parameter adjusts the reverb depth.
* For more information about reverb, please refer to page 22.
2 .1 EFX
1. Category 23 categories
This parameter selects the eect category.
* For more information about eects, please refer to page 23.
* The E.PIANO section lists two pages for EFX1 and EFX2.
2. Type 129 types
This parameter selects the eect type.
* For more information about eects, please refer to page 23.
* The E.PIANO section lists two pages for EFX1 and EFX2.
3. Parameters n/a
These parameters change depending on the selected EFX type,
and are used to adjust the mixing amount of the eected (wet)
and bypassed (dry) sound, depth, speed, feedback, etc.
* For more information about eects, please refer to page 23.