Kawai MP11SE - Key Setup

56
EDIT Menu
EDIT Menu parameters (MIDI OUT)
5 Key Setup
1. Touch Curve
6 types + 5 user
This parameter selects the touch response curve of the keyboard
for the selected zone.
* For more information about touch curve types, please refer to page 45.
* For information about creating User Touch Curves, please refer to the User
Edit explanation in the SYSTEM menu chapter (page 106).
2. Dynamics value: off, 1 ~ 10
This parameter adjusts the keyboard response (velocity
compression) of the selected zone independently of the touch
curve.
* For more information about dynamics, please refer to page 45.
3. Transmit Keyboard
on, off
This parameter determines whether or not keyboard Key ON/
Key OFF event data will be transmitted to an external MIDI
device.
4. Octave Shift value: –3 ~ +3 octaves
This parameter adjusts the amount of octave transposition for
the selected zone.
5. Zone Transpose value: –12 ~ +12
This parameter adjusts the amount of transposition for the
selected zone.
6. Key Scaling Damping on, off
This parameter determines whether or not damping (velocity
reduction) should be applied to a zone over a specic range.
7. Key Scaling Key range: a0 ~ c8
This parameter denes the point on the keyboard from which
Key Scaling Damping should be applied, up to the highest key.
8. Key Range Type off, upper, lower, zone
This parameter selects the Key Range type for the selected zone.
Type Description
O The zone is used for all 88 keys of the keyboard.
Upper The zone is used for the upper split.
Lower The zone is used for the lower split.
Zone The zone is used for a dened zone between two keys.
* This parameter is not stored to SOUND but to SETUP only.
9. Split Point range: a0 ~ c8
This parameter denes the point on the keyboard at which the
upper and lower parts are divided.
* For more information about Key Range functions, please refer to page 26.
* This parameter is common for all three sound sections and all MIDI zones.
10./11. Key Range Zone Lo/Hi range: a0 ~ c8
These parameters dene the bottom and top keys of the key
range zone.
* For more information about Key Range functions, please refer to page
26.
12. Solo on, off
This parameter determines whether or not playing will be
restricted to single notes, even when more than one note is
played simultaneously.
This parameters can be used to eectively simulate the performance
characteristics of a monophonic synthesizer.
13. Solo Mode last, HigH, low
This parameter selects the solo mode for the selected zone.
Solo Mode Description
Last Play the last note of a group of notes.
High Play the highest note of a group of notes.
Low Play the lowest note of a group of notes.