KBL mega Sun K9S - Page 44

Assembly Instructions | megaSun K9S
44
Assembly steps Refer to chapter
Assemble the feet
• Assemble the feet
• Connect left side connector and install the paneling
• Connect right side connector
4.16
Install lower part of the canopy
• Install Canopy
• Fasten intake air boots and mount cables and hoses
4.15
5.1
4.15.1
Install upper part of the canopy
4.14
Assemble the canopy
• Install upper paneling
• Install side paneling
• Install WiFi / Bluetooth antenna
• Connect USB cable
• 
• Connect the plug at the bottom right
• 
• Install the plastic cladding
• Fasten the set screw
4.13
Fold down the canopy
4.12
Install the rear air duct
• Install air duct
• Connect the plugs
4.11
Assembly sequence
Assembly is performed in reverse order to the dis-
󰀨
are marked in red.
5. Assembly