Assembly Instructions | megaSun K9S
7
2. Safety notes
2.1 General safety advice
• This tanning device was designed exclusively for
use in a commercial environment.
• Follow all instructions given in this manual. In addi-
tion, observe all relevant statutory provisions and
regulations, also those applicable in the country of
operation.
• The tanning device may only be installed and set
up by trained and authorised personnel having
received safety-related instruction.
• -
ment are not permissible.
• Observe all danger signs and safety notices
attached to the equipment.
• Safety notices must not be removed, and safety
equipment must not be disabled or removed.
• The tanning device must only be operated when in
perfect working condition.
• Never operate the tanning device with the outer
covers or acrylic panes removed.
• Absolutely observe the maintenance frequencies
indicated in the maintenance plan.
• Pay attention to the load limit of the bench pane
(tanning bed units only).
• The bench must only be opened with the bench
pane folded down.
The canopy is not designed to carry
additional loads.
• Do not lean on or over the canopy.
• Before carrying out any work, the tanning device
must be disconnected from the mains voltage.
DANGER
Live parts
Risk of death or fatal injury due to elec-
tric shock when touching live parts.
• Switch neutral
• Secure against reconnection
• Check for neutrality
• Ground and short-circuit
• Cover or shield any adjacent live parts
or components
DANGER
Damaged mains power cable
Risk of death or fatal injury due to
electric shock by touching a damaged
mains power cable.
•
service technicians are permitted to
replace the mains power cable!
To Next Page
Loading...
