Rev. 1.00
22585_EDEBDA0252-0318-1_EN
9
KBR multicomp F144-3 6DO/12DO
The settings are saved on an EEPROM so that they are not lost in the event of a
power failure.
The measuring cycle of the controller used to record the necessary network
parameters takes approx. 20 ms.
NOTE
Limit for overvoltage switch-o = measuring voltage + 10% (taking the mea-
suring voltage ratio into account). This value cannot be changed and serves to
protect the compensation system.
In the event of an error, the compensation stages are switched o and "Over-
voltage" is displayed.
Functional principle
To Next Page
Loading...
