Need help?Do you have a question about the KBR Multicomp 2F144-NC-1V1C06RO and is the answer not in the manual?
General| Brand | KBR |
|---|---|
| Model | Multicomp 2F144-NC-1V1C06RO |
| Category | Controller |
| Language | English |
Explains meanings of Danger, Warning, Caution, and Note symbols used in the manual.
Covers essential safety measures for installation, operation, and maintenance of the device.
Information on product quality, testing, and warranty conditions.
Guidance on proper disposal of defective or outdated devices.
Emphasizes tightening connections and complying with VDE/energy supplier regulations.
Details on connecting current transformers and measurement voltage for optimal operation.
Explains how current transformers are dimensioned based on consumer current and other factors.
Wiring diagram for Ph-N measurement voltage connection.
Wiring diagram for Ph-Ph measurement voltage connection.
Steps and conditions for successful facility commissioning and controller activation.
Programming and checking requirements for the controller within a compensation facility.
Initial setup displays, including initialization and commissioning without programmed stage power.
Displays current CosPhi and controller status after programming.
Shows capacitor stage states, service info, and allows deletion of switching cycles.
Step-by-step guide for commissioning the controller and configuring parameters.
Settings to adjust hysteresis, delays, and intervals for switching behavior.
Configures how error messages are displayed and handled (Off, Message, Alarm Relay).
Access to additional settings like language, THD limit, scanning frequency, and stage monitoring.
Details on measured and displayed electrical values like voltage, current, frequency, power, and power factor.
Specifies the accuracy tolerances for current, voltage, power, and frequency measurements.
Explains the internal principles for reading, measuring, and calculating values.
Details device power requirements and electrical connection specifications.
Lists and describes the device's physical input and output interfaces.
To Next Page
