© 2019 KCodes Corporation. All rights reserved. 6 Series User’s Manual V1.0
6. Then try to issue a print job to the desired printer. You will see the Control Center will
automatically do a connect operation. Then, the print job will be issued to that printer.
7. Even you already properly setup an auto-connected printer, the Control Center must be running
(in the background) while a print job is issued. This means you’d better run the Control Center
every time after you login Windows. In order to skip this manual operation, you can make the
Control Center be run automatically after you login Windows. To do this, choose the
“Configuration” item in the “Tools” menu. The following window will appear. Click on the check
box and then on the “OK” button. This feature is enabled by default.
To Next Page
Loading...