KDK 40BECH - Page 10

安裝方法
HOW TO INSTALL
推入 時 請注 意不要夾傷 線。機體 ，
Push the main body upward into the ceiling board
and wooden frame by closely leaning against the
adapter, clip the clipping position of the main body
into the locating slot of the adapter (otherwise,
may have air leakage), and fix the main body with
six 4 x 30 self- tapping screws.
6
提示事 項
Notice
Please be careful not to pinch the cord, when push
upward the main body.
將機體 緊靠出風口接頭往上 推入天花板 與木框，
(否則漏 風)，並使機 體上卡位卡入出風口 接頭定位槽 中
用 顆 的自攻 螺絲將機體牢固地固 定6 4x30 。
Locating slot of the adapter
出風口 接頭定位槽
Clipping position
of the main body
機體卡 位
Self-tapping
screws
4 x 30 (6 pcs)
自攻螺 絲
4x30(6 )顆
10
Loosen the screws of the cord clip.
將固定 電源線線夾的螺絲鬆 脫。
Loosen the screws of the pillar terminal , insert the
power cord(not supplied)connected to the fixed
wiring which in the house into the pillar terminal ,
tighten the screw.
鬆開接 線柱上的螺絲，將接 入室內固定 線路的電源 線
（用戶 自購）插入接線柱， 擰緊接線柱 螺絲。
Fix the cord cover by the screws which
removed by step .
用步驟 拆 下的螺絲 將接線蓋板重新固定。，
用線夾 將電源線固定。
(線夾必 須壓住電源線絕緣護套)
Fix the power cord with the cord clip.
(The cord clip must pin the insulation
sheath of power cord.)
注意
CAUTION
When covering the terminal cover, be sure not to suppress
the earth wire, otherwise it may damage the earth wire.
蓋端子 保護蓋時，請注意不 要壓到地線 ，否則可能 會壓傷地線。
Screws
螺絲
線夾
Cord clip
Terminal
接線柱
地線
Earth
wire
Screws
螺絲
線夾
Cord clip
Terminal cover
端子保 護蓋
5
-2
5
-3
5
-4
5
-5
5
-1
5
-1