KDK 40BECH - How to Install
8

安裝方法
HOW TO INSTALL
Please back the remote control to the holder.
將遙控 器放回遙控器底座。
在浴室 的牆壁上開2顆 6的安裝孔，將遙控器
底座安 裝於牆上。
Open two 6 holes in the bathroom wall
as shown below. And install the controller
holder.
Do not short circuit.
Please observe the following when using the batteries.
電池的 使用請遵守以下內容。
勿將電池正負反裝。
勿將新舊、異種電池混合 使用。
長期不 使用時，請取出電池 。
更換電 池時，請擦乾遙控器 機體後進行 更換。
不可短路。
(否則可能會導致漏液或破 損)。
警告
WARNING
Do not inversely install the positive
pole and negative pole of batteries.
Do not use an old battery together
with a new battery or use different
types of batteries in a mixed way.
(Otherwise, aleakage or damagemaybecaused.)
2.Do not replace the batteries when the remote control body is wet.
1.lf you will not use the remote control for a period of time, take out the batteries.
3.Do not exert too hard when you rotate the" " knob on the remote control back,
otherwise the knob will be damaged.
旋動遙 控器背部 字旋鈕時，請勿用力過大 ，否則可能 會損壞該旋鈕。
丟棄電 池時，請遵循當地法律法規。
Please comply with local laws and regulations when dispose the battery.
提示事 項
Notice
Install two R03(AAA) carbon batteries in the
remote control.
將2粒R03(AAA)炭性電池放入遙控 器中。
4.If the battery cover is not tightened, it will affect the sealing effect.
如果電 池蓋未蓋緊，會影響密封效果。
膠塞( 6×26 mm)(另購)
36 mm
自攻螺 絲( 4×16 mm)
2-
6
深
2
8 mm
2-6
2
8 mm
Plastic plug( 6 x 26 mm)
(not supply)
Self-tapping screw
( 4 x 16 mm)
供安装人员阅读
將旋鈕 向 左轉至
“ ”位置
(1)Rotate the knob “ “
leftward to the “ ”
position.
[關]的狀態
[Close]status
[開]的狀態
[Open]status
(3)Install two R03(AAA) carbon
batteries in the remote control.
(Pay attention to the directions of
“ ” and “ ”)
將兩粒R03(AAA)炭性電 池放入遙控
器中。(注 意 ， 方向)
(4)Replace the battery cover.
重新蓋 上電池蓋。
將旋鈕 向 右轉至“ ”位置。
(5)Rotate the knob “ ” rightward to
the “ ”position.
旋鈕
knob
17
打開電 池蓋。
(2)Open the battery cover.