KDK 40BECH - 目錄; 安全指引; Installation Requirements 5; Supplied Accessories

6
包裝附件清單
SUPPLIED ACCESSORIES
When you install plastic part, do not exert too much strength to fixing the screw,
otherwise, the product would be damaged.
安裝塑料部件時，為了不 損壞產品，鎖螺絲時請注 意不要用力過大。
安裝要求
INSTALLATION REQUIREMENTS
The product is not provided with power cord, all-pole switch and leakage
protection switch. Please purchase them in market.
本產品沒有提供電源線， 電源全極開關和漏電保護 開關，需用戶另購。
4
7
1
3
1
1
1
1
2
3
2
1
2
1
3
4
5
6
7
8
9
10
11
12
Qty
No.
Drawing
Name and Purpose
Self-tapping screw ( 4 x13, used to install the main
body and the suspension bracket )
Adapter
Suspension bracket (placed in the packaging foam)
代號
圖樣
名稱及 用途
數量
Machinescrew(M4×10,usedtoinstallthelouver assembly)
機械螺 絲(M4×10用於面板 組合安裝)
自攻螺 絲( 4×13用於機體 與懸吊支架的安裝)
Product warranty registration
產品保 修登記
Installationandoperatinginstructions
安裝使 用說明書
Louver assembly
面板組 合
Remote control assembly(placed in the packaging foam)
遙控器 組合(放於包裝泡沫中)
出風口 接頭
懸吊支 架(放於包裝泡沫中)
R03(AAA) Carbon battery
R03(AAA)炭性電池
Self-tapping screw
( 4×8,used to prevent the main body from falling )
自攻螺 絲（ 4×8用於機體防跌落）
13
Installation cardboard
安裝用 紙板
1
Self-tappingscrew
( 4×30,usedtoinstallthemain body and the adapter)
自攻螺 絲( 4×30用於機體 及出風口接頭的安裝)
Self-tappingscrew( 4×16,usedtoinstallthecontroller
holder) (placed on the backside of controller holder)
自攻螺 絲( 4×16用於遙控 器底座安裝)(放置於遙控器底座背 面)
Machinescrew
(M4×8,usedtofix the louver and the main body)
2
機械螺 絲(M4×8用於面板與機 體固定)
14