KEB 7608000-4001

11
STANDARDS FOR ASYNCHRONOUS AND SYNCHRONOUS MOTORS
insulation systems (Type I) used in rotating electrical machines fed from voltage
converters-Qualicationandqualitycontroltests(IEC60034-18-41)
EN 60034-18-42 Rotating electrical machines - Part 18-42: Partial discharge resistant electrical
insulation systems (Type II) used in rotating electrical machines fed from voltage
converters-Qualicationtests(IEC2/1798/CDV)
IEC/TS 60034-24 Rotating electrical machines - Part 24: Online detection and diagnosis of
potential failures at the active parts of rotating electrical machines and of bearing
currents - Application guide (IEC/TS 60034-24)
IEC 2/1689/CD Rotating electrical machines - Part 25: AC machines when used in power drive
systems - Application guide (IEC 2/1689/CD)
DINEN60034-30-1 Rotatingelectricalmachines-Part30-1:EfciencyclassesoflineoperatedAC
motors (IE code) (IEC 60034-30-1)
DIN CLC/TS 60034-31  Rotatingelectricalmachines-Part31:Selectionofenergy-efcientmotors
including variable speed applications - Application guide (IEC/TS 60034-31)
DIN 748-3 Cylindrical shaft ends - Part 3: For rotating electrical machinery
DINSPEC42955 Shaftextensionrunoutandofmountingangesforrotatingelectricalmachinery,
frame size larger then 315 - Tolerances, test
DIN EN 50347 General purpose three-phase induction motors having standard dimensions and
outputs-Framenumbers56to315andangenumbers65to740
DIN6885-1 DriveTypeFasteningswithoutTaperAction;ParallelKeys,Keyways,DeepPattern
DIN 332-2 Center holes 60° with thread for shaft ends for rotating electrical machines