4.2.2 Encoder connection servo motor 7607613-40xx
WARNING
Adjustment of the measuring system
The measuring system of synchronous motors must be adjusted to the
respective inverter. Any mis-adjustment may lead to uncontrolled motor
response or complete failure of the motor.
In order to avoid any risk, the motor must be put into operation only in
no-load operation, without connection to the system.
Description View Pin Nr. Signal
View of the connector pins of the
resolver
5
9
1
6
1 R2 (Ref-)
2 R1 (Ref+)
3 S3 (Cos-)
4 S1 (Cos+)
5 S2 (Sin+)
6 S4 (Sin-)
7 GND
8 Shield
9 Not connected
Figure 16: Terminal assignment of the resolver plug for servo motor 7607613-40xx
4.2.3 Connection of the brake and temperature monitoring for servo motor 7607613-40xx
Description View Pin Nr. Signal
View of the brake and tempera-
ture connector
1 4
5
8
1 Brake +
2 Brake -
3 Temp.1 +
4 Temp.1 -
5 Temp.2 +
6 Temp.2 -
7 Not connected
8 Not connected
Figure 17: Pin assignment of the brake connection and temperature monitoring for servo motor 7607613-
40xx
42
CONNECTION
To Next Page
Loading...