KEB 7608000-4001

16
BASIC SAFETY INSTRUCTIONS
1.4.1 EMC-compatible installation
Observance of the limit values required by EMC law is the responsibility of the manufac-
turer of the installation or machine.
Notes on EMC-compatible installation can be found here.
0000ndb0000.pdf
1.5 Start-up and operation
The drive converter must not be started until it is determined that the installation com-
plieswiththemachinedirective;AccountistobetakenofEN 60204-1.
WARNING
Software protection and programming !
Hazards caused by unintentional behavior of the drive!
► Check especially during initial start-up or replacement of the drive
converter if parameterization is compatible to application.
► Securing a unit solely with software-supported functions is not suf-
cient.Itisimperativetoinstallexternalprotectivemeasures(e.g.
limit switch) that are independent of the drive converter.
► Secure motors against automatic restart.
CAUTION
High temperatures at heat sink and coolant!
Burning of the skin!
► Cover hot surfaces safe-to-touch.
► Before working let the motor cool down.
► Before touching, check the surface and cooling water lines.
► If necessary, attach warning signs on the system.