Fig.10-3: Fan case with fan
1
... Connector
2 ... Fastening screw with pressure spring
Ordering information
Designation Comment Order number
Fan case with cae for CP 25x moduls 76105
Replacing the fan
CAUTION
Do not use force!
Otherwise you risk bending the connections on the ventilator case.
Replace fan according to the following the instructions:
1) Disconnect power supply.
2) If necessary dismount the module.
3) Loose the screw on the fan case with a screwdriver. By reason of the spring
the loosen screw would not get seperate from the fan case.
4) Pull out fan case in a straight way.
5) Insert new fan with fan case. Pay attention to the mounting direction, like
displayed in the picture.
Maintenance
CP 263/S, CP 263/X
© KEBA 2014
Project engineering manual V1.0136
To Next Page
Loading...
