General safety instructions SANMOTION C FM 299/A
8 Project Engineering Manual, version: 1.1 / article no.: 1000296
© KEBA 2006
2 General safety instructions
z The device is defined as an "open type equipment" so that it must be
installed in a control cabinet.
z The safety instructions in the project engineering handbook "K2-200
automation system” are to be complied with.
CAUTION
• Turn off the power supply before inserting or removing the module. Otherwise,
the module can be destroyed or undefined signal states can lead to damage of
the control system.
To Next Page
Loading...
