KEENCUT Evolution E2 User Manual

2.4 Before Set Up 2.4
Lift the Evolution E2 cutter bar from its crate but do not remove the clear plastic
stretch-wrap bands holding the base to the cutter bar. Place the Evolution E2 centrally
on the Brackets and manoeuvre it until the base is located properly down on each of
the Brackets.
Tighten the grub screws "
B" at the back of each of the Brackets by 4 full turns and then
tighten the front grub screws "
A" fully (approx 4- 6 turns). Remove the clear plastic
stretch-wrap bands.
➤
➤
➤
B
A

KEENCUT Evolution E2 Specifications

General

Brand	KEENCUT
Model	Evolution E2
Category	Cutter
Language	English