EasyManua.ls Logo

Keiser 300 - Upholstery Care and Decal Replacement; Decal Removal and Application Process; Decal Handling Safety Precautions

Keiser 300
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
25
UPHOLSTERY
The upholstery should be wiped down daily with a dry soft cloth. Once a week, wash the
upholstery with the warm water and mild dish soap (Joy, Ivory, Dove, etc..), or a cleaner
made for Naugahyde. Waxing the upholstery once a month will increase the life of the
Naugahyde. Use a hard wax such as “Johnson Glo-Coat” or ‘Simoniz”. Most cushions
can be rotated to allow them to wear evenly. To do this use the following procedure:
TOOLS REQUIRED: 5/16 & ½ inch wrenches or sockets
Remove the bolts holding the cushion to the frame and turn it around. If the upholstery is
worn or damaged, the cover can be replaced at a lower cost than replacing the whole
cushion. Contact KEISER for details.
DECAL REMOVAL AND REPLACEMENT
Damaged decals can be removed by simply peeling them off the surface. The surface
must then be thoroughly cleaned of all dirt, grease, perspiration, and adhesive left from
the old decal. Apply the new decal making sure that no air bubbles are under it.
Immediately wax the new decal and the area around it.
CAUTION: SOME DECALS MAY HAVE SHARP EDGES. USE CARE WHEN
HANDLING THEM.
NOTICE: DO NOT USE SHARP INSTRUMENTS THAT WILL SCRATCH THE
CHROME. IF IT IS NECESSARY TO USE ALCOHOL OR PETROLEUM BASED
SOLVENTS TO REMOVE THE DECALS, CARE MUST BE TAKEN TO PREVENT
THESE SOLVENTS FROM COMING IN CONTACT WITH THE UPHOLSTERY.
THE CLEANED ARE MUST BE WAXED AS SOON AS POSSIBLE TO PREVENT
CORROSION OF THE CHROME.

Related product manuals