30
LATERAL SHOULDER RAISE
CYLINDER ADJUSTMENT
NOTICE: CYLINDERS ARE FACTORY-ADJUSTED AND REQUIRE NO
FURTHER ADJUSTMENT UNLESS THEY ARE REPLACED. Please contact
KEISER if you have any questions concerning adjustments or repairs.
1. Check the condition of the rubber crutch tips that the exercise arms rest against.
These must not be worn or damaged in any way. If they are worn replace them
before attempting to adjust a cylinder.
2. Pull up on the rod until the cam follower touches the cam. With no resistance, check
the feel of the action. If the rod seems to stick or hesitate at full extension, the piston
may be bottomed-out against the end housing. If the piston is bottomed-out, lengthen
the rod three full turns down (pg. 13 in the Maintenance Manual).
To Next Page
Loading...
