32
the adjusting drag link, bottom. Drive the pin into the adjusting drag link, bottom,
through the hole in the adjusting drag link, top. The spring pin should stick out 1/16”
from each side of the adjusting drag link, bottom.
2. To install the spring pin 3/16 X 7/8 (item # 2) in the exercise arm mount (item # 4),
line up the hole in the exercise arm mount with the hole in the exercise arm pivot
shaft (item # 13). Drive the spring pin in until the end is 1/16” into the exercise arm
mount.
To Next Page
Loading...
