To Next Page

To Previous Page

Series 3700A System Switch/Multimeter Reference Manual Section 11: TSP command reference

3700AS-901-01 Rev. D/June 2018 11-151

An error is generated if:

• You try to set dmm.autozero for "continuity" or "nofunction". Error code 1114, "Setting

conflicts with function selected," is generated.

• You query dmm.autozero for "continuity" or "nofunction". nil is returned with error

code 1114, "Setting conflicts with function selected."

Example

dmm.func = "dcvolts"

dmm.autozero = dmm.ON

dmm.autozero = dmm.AUTOZERO_ONCE

print(dmm.autozero)

timer.reset()

dmm.autozero=2

time=timer.measure.t()

print(time)

Enables autozero for DC volts.

Refreshes the reference points once and sets

autozero to dmm.OFF or 0.

Output:

0.000000000e+00

Determines the time delay when autozero is selected.

Also see

Autozero (on page 4-3)

dmm.configure.recall() (on page 11-165)

dmm.configure.set() (on page 11-166)

dmm.func (on page 11-179)

dmm.nplc (on page 11-209)

dmm.reset() (on page 11-219)

reset() (on page 11-308)

Keithley 3720 Reference Manual

Other manuals for Keithley 3720