Series 2600 System SourceMeters Reference Manual Getting Started 1-5
Return to Section 1 topics 2600S-901-01 Rev. A / May 2006
Options and accessories
Connectors
SourceMeter DUT Interface Connector Kit – Includes one hooded screw
terminal connector that mates with the SourceMeter measurement terminals.
One kit per channel is included with the SourceMeter.
GPIB cables and adapter (connects Series 2600 to the GPIB bus):
Model 7006-1 and Model 7006-2 – Single-shielded GPIB cables. Terminated
with one straight connector (non-stacking) and one feed-through style
connector. Model 7006-1 is 1m long; Model 7006-2 is 2m long.
Models 7007-05, 7007-1, 7007-2 and 7007-4 – Double-shielded premium
GPIB cables. Each end is terminated with a feed through metal housing for
longest life and best performance. Model 7007-05 is 0.5m long; 7007-1 is 1m
long; Model 7007-2 is 2m long; Model 7007-4 is 4m long.
Model 7010 – Shielded IEEE-to-IEEE Adapter. Provides additional clearance
between the rear panel and GPIB cable connector. Allows easier access to
cables and other connectors.
RS-232 cable (connects Series 2600 to the RS-232):
Model 7009-5 shielded RS-232 cable – This straight-through cable connects
the RS-232 of the Series 2600 to the RS-232 interface of the PC. This cable is
5ft. long and uses shielded cable and connectors to reduce electromagnetic
interference (EMI).
TSP-Link cable (connects Series 2600 to the TSP-Link):
CA-180-3A CAT 5 cable – This crossover CAT5 LAN cable connects the
TSP-Link of the Series 2600 to the TSP-Link of other instruments.
Digital I/O port cables (connects Digital I/O to other devices):
Model 2600-TLINK trigger cable – Connects the Digital I/O port of series
2600 instruments to other Keithley instruments equipped with Trigger Link
(TLINK).
CA-126-1 DB-25 cable – DB-25 male to female DB-25 cable, 1.5m (5ft) long,
used to connect the Digital I/O port to other instruments.
To Next Page
Loading...
Need help?
General
