12-114 Instrument Control Library Series 2600 System SourceMeters Reference Manual
2600S-901-01 Rev. A / May 2006 Return to Section 12 topics
status.operation.user.*
status.operation.user.condition
status.operation.user.enable
status.operation.user.event
status.operation.user.ntr
status.operation.user.ptr
* = condition, enable, event, ntr or ptr
Attribute Operation user event register set.
Usage Reads condition, enable, event, NTR and PTR registers:
operreg = status.operation.user.condition
operreg = status.operation.user.enable
operreg = status.operation.user.event
operreg = status.operation.user.ntr
operreg = status.operation.user.ptr
Writes to condition, enable, NTR and PTR registers:
status.operation.user.condition = operreg
status.operation.user.enable = operreg
status.operation.user.ntr = operreg
status.operation.user.ptr = operreg
Set operreg to one of the following values:
0 Clears all bits.
status.operation.user.BIT0 Sets user BIT0.
status.operation.user.BIT1 Sets user BIT1.
status.operation.user.BIT2 Sets user BIT2.
status.operation.user.BIT3 Sets user BIT3.
status.operation.user.BIT4 Sets user BIT4.
status.operation.user.BIT5 Sets user BIT5.
status.operation.user.BIT6 Sets user BIT6.
status.operation.user.BIT7 Sets user BIT
status.operation.user.BIT8 Sets user BIT
status.operation.user.BIT9 Sets user BIT
status.operation.user.BIT10 Sets user BIT
status.operation.user.BIT11 Sets user BIT
status.operation.user.BIT12 Sets user BIT
status.operation.user.BIT13 Sets user BIT
status.operation.user.BIT14 Sets user BIT
operreg can also be set to the decimal weight of the bit to be set. Examples:
To set user BIT0, set operreg to 1 (2
0
).
To set user BIT4, set operreg to 16 (2
4
).
To set user BIT11, set operreg to 2048 (2
11
).
To set more than one bit of the register, set operreg to the sum of their decimal
weights. For example, to set BIT0 and BIT4, set
operreg to 17 (1 + 16).
To Next Page
Loading...
Need help?
General
