1-24 Getting Started Series 2600 System SourceMeters Reference Manual
2600S-901-01 Rev. A / May 2006 Return to Section 1 topics
Remote operation setups
Saving and restoring user setups
The setup.save and setup.recall commands are used to save and recall
user setups:
setup.save(n)
setup.recall(n)
where:
n = 1, 2, 3, 4 or 5
--
--
Save present setup in memory.
Recall saved user setup from memory.
Restoring default setups
The reset commands return the Series 2600 to the original factory defaults:
reset() --Restore all factory defaults.
smua.reset() --Restore Channel A defaults.
smub.reset() --Restore 2602/2612 Channel B defaults.
Selecting power-on setup
The setup.poweron command is used to select which setup to return to on
power-up:
setup.poweron = n
where:
n = 0 (*RST defaults)
n = 1 to 5 (user setups 1-5)
--Select power-on setup.
To Next Page
Loading...
Need help?
General
