Output current accuracy limits 15-13, 15-14
Output enable 10-9
Control 10-10
control 10-9
Operation 10-9, 10-11
Output voltage accuracy 15-8
Output voltage accuracy limits 15-9
Output-off states 3-18
Overheating protection 8-6
P
Phone number 1-3
Power
Calculations 4-22, 8-7
Equations 8-6
Measurement procedure 4-22, 4-24
Measurements 4-22
Programming example 4-23
Remote programming 4-23, 4-24
Power module 1-11
Power switch 1-8
Power-on setup 1-23, 1-24
Power-up 1-13
Sequence 1-14
Precedence 2-57
PRESet default setup 1-24
Primary address 11-5
Pulse
Concepts 8-32
Duty cycle 8-33
Period 8-32
Rise and fall times 8-32
Sweeps 5-6
Pulse characteristics
Pulse duty cycle 8-33
Pulse energy limitations 8-31
Pulse sweeps 8-5
Q
Queries 2-4
Queues D-2, D-32
Error D-32
Output D-32
R
Range 6-2
Auto 6-3
Auto range limits 6-4
Available ranges 6-2
Commands 6-5
Considerations 6-4
Limitations 6-3
Low limits 6-4
Manual 6-3
Programming 6-5
Programming example 6-6
Reading buffers 12-6
Readings
Maximum 6-3
Recalling 7-4
Requesting 1-26, 4-16
Storing 7-3
Rear panel summaries 1-6
Recalling readings 7-4
Recommended test equipment 15-3
Recommended verification equipment 15-4
Reference manual 1-6
Registers
Enable and transition D-15
Measurement event D-28
Operation event D-20
Programming example D-32
Questionable event D-25
Reading D-11
Serial polling and SRQ D-14
Service request enable D-13
Standard event D-18
Status sets D-17
System summary event D-17
Rel 6-10
Defining a value 6-10
Enabling and disabling 6-10
Front panel 6-10
Remote programming 6-11
REM 11-9
Remote calibration 16-5
Remote operation
Source-measure procedure 4-14
Remote programming 1-26
Ohms 4-21
Power 4-23, 4-24
REN (remote enable) 11-7
Restoring factory defaults 15-5
Rise time 8-32
Rotary knob 1-9
RS-232 cable 1-5
RS-232 Interface
Terminator 11-11
RS-232 interface
Baud rate 11-12
Connections 11-13
To Next Page
Loading...
Need help?
General
