6 Indoor display unit Kelvinator Air Conditioning
Indoor display unit
will blink for about 1 second on the display of the
remote control.
caution
other materials block the signals from the remote control
to the indoor unit.
Do not expose the remote control to direct sunlight
or heat.
exposed to direct sunlight, the air conditioner may not
function properly. Use curtains to prevent the sunlight
from falling on the receiver.
• Ifotherelectricalappliancesreacttotheremote
control, either move these appliances or consult your
local dealer.
Replacing batteries
The remote control uses two AAA dry cell batteries.
1 Slide the cover of the battery compartment off according
to the arrow direction, then replace the old batteries with
new ones.
2 Insert the new batteries making sure that the (+) and (-) of
the batteries are installed correctly.
3 Reattach the cover by sliding it back into position. The
remote control clock will need to be reset after replacing
the batteries.
NOTE: Do not dispose batteries as unsorted municipal
waste. Collection of such waste separately for special
treatment is necessary.
tips and information
batteries, otherwise, it may cause problems with the
remote control.
the batteries as old batteries may leak or corrode and
damage the remote control.
remove and refit the batteries. If abnormal operation
continues, replace with new batteries.
1 I feel indicator
2 Turbo indicator
3 Eco (economy) indicator
4 Temperature indicator
Displays the temperature settings when the
air conditioner is in operation.
5 Timer indicator
ON or OFF.
6 Swing indicator
7 Signal receiver
Receives signal from the remote control.
Remote control
Location of the remote control
receiver of the indoor unit (a distance of up to 8m is allowed).
automatically transmits a signal to the indoor unit at the
specified time.
proper signal transmission, a time lag of up to 15 minutes
may occur.
1 2 3 4 5 6 7
up to 8 metres
To Next Page
Loading...
Need help?
General
