5.1 Basic adjustments C3000
Mounting on tractor
3-point hitch
Hydraulic connection
Connect the 3-point hydraulic of the
tractor with the chopper. Fix bottom
attachment points against lateral
movement.
Choose tractor hydraulic on
„Position“ control
Choose PTO 1000 U/pm
The 3 point hitch has two connec-
tion facilities: in the middle of the
machine or offset
150 mm
on the
side.
You should select the connection
affording the lowest cardan shaft
extension in the working position.
The gap between the chopper
casing and flat ground should be
about
5
cm
The chopper needs two hydraulic
valves 1 doubble effect and
1 simple effect
Clean hydraulic tubes before
connecting.
SE = header cylinder
DE= Chute move
To Next Page
Loading...
