Basic adjustments C3000
Adapt PTO shaft
Main drive
Attention: ball clutch has always to
be fixed on the chopper side!
The length has to be adapted
corresponding to the tractor. The
minimum doubling of the shaft is
150mm
The PTO shaft for tractors over
200hp cannot be adapted
!!
Tractors with more than 200 hp need
special frame adapter The distance
between chopper and frame is lifted
up of 115mm.
Weld on the adapters after
adjustment!
The Champion chopper is factory set
for connection to the 1000 rpm PTO
To Next Page
Loading...
