5.5 Whole crop harvesting C3000
Generel
To obtain a proper cut, the rotation speed of the saws for thin-stemmed crops
should be higher than for maize or sunflowers.
In our experience, it is correct when the gathering drum speed is at least 28-36
rpm.
CAUTION The maximum speed of the gathering drum of 40 to 54 rpm must not
be used due to the risk of injury (see introduction 4.12). The saw speed would
likewise be too high.
Note:
It can be seen from the chart that when selecting the corresponding feed to
achieve the required cutting length, there are only certain ways of connecting the
plug combinations on the PT0 for the pick-up unit drive.
e.g.
Chopping length 6.5 mm
F. e-e.d - 3
PT0 connection 1-1
To Next Page
Loading...
