5.7 Interchangable plates C3000
Improtant:
Place center bolts into wholes in
housing for correct working
The side cracing plate can adjusted to different corn diameters
The cracking plate works by means of an interchangeable perforated plate and varying
the gap from the rocker paddles: The plate must fit flush at the bottom.
The gap is 8 mm at section A-B, and 3 mm at section C-D.
The bolt A is factory side put at 10
mm distance.
The bolt B is factoy side put at 3 mm
distance.
Release security nuts
After changing the distance tighten
security nuts.
A B
back
To Next Page
Loading...
