Front Panel Controls Stage 48
Module and Section Buttons (4)
These buttons are associated with the modules and section of the signal chain as described in the chapter Rigs and
Signal Chain before. A short press will switch the associated module or section on and off. Press longer to open the
associated menu. Once inside a menu use the PAGE buttons to scroll through pages of parameters. To open the
stack section, press AMPLIFIER and CABINET buttons simultaneously.
OUTPUT/MASTER Button (5)
This button brings the settings of the Output Section into focus. These are:
• volume settings for different outputs
• Volume Link soft buttons to link and unlink the individual volumes to the MASTER VOLUME knob
• Output Sources to feed the outputs with different signals
• separate Main Equalizer and Monitor Equalizer
• “Monitor Cab Off”, a global switch to bypass the virtual speaker cabinet individually for the MONITOR OUTPUT
By engaging “Monitor Cab Off” you can run the PROFILER directly to a power amp driving a physical guitar cabinet
on stage, while the MAIN OUTPUT still carry the full signal, including the virtual speaker, which would be connected
to the front mixing desk.
All the settings in the Output Section are global (or “locked”) and will therefore not be saved with the Rig. However,
as with all other modules, you can save the settings for the Output Section as presets. This allows you to create
output presets with adjustments tailored to specific venues, studios or rehearsal rooms.
✓ Read more about the settings in the Output Section and special applications in the chapter Output Section; there is
also a tutorial video specifically about the Output Section and recording setups, which can be found on:
www.kemper-amps.com/video
To Next Page
