Kemper PROFILER - Page 64

Kemper PROFILER

315 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Basic Setups 64

This studio setup shows the PROFILER connected to a DAW with studio monitors attached.

Table of Contents

Legal Notice2
- Table of Contents3
Table of Contents19
About this Main Manual19
Rigs and Signal Chain20
- Effect Modules21
- Effect Presets22
- Effect Select Screen22
- Clear Effect23
- Autoload23
- Load Defaults24
- Load Type24
- Auto Type24
- Stack Section25
Front Panel Controls Head, Powerhead, Rack, and Powerrack26
- Chicken Head Knob27
- Input Led29
- Module and Section Buttons29
- Output Led30
- NOISE GATE Knob30
- Direct Control Knobs31
- MASTER VOLUME Knob31
- TAP Button32
- SYSTEM Button32
- RIG Button32
- QUICK Button33
- TYPE Knob33
- BROWSE Knob33
- Soft Buttons and Soft Knobs34
- ON/OFF Button34
- LOCK Button34
- COPY and PASTE Buttons35
- STORE Button35
- UNDO and REDO Buttons36
- EXIT Button36
- PAGE> Buttons36
- RIG Navigation Cross37
- HEADPHONE Output37
- GAIN Knob37
- RIG VOLUME Knob37
- Front INPUT38
- Usb38
Back Panel Overview Head, Powerhead, Rack, and Powerrack39
- Main Output40
- Monitor Output40
- Direct Output/Send41
- RETURN and ALTERNATIVE INPUT41
- Power42
- Network42
- Switch/Pedal42
- MIDI43
- S/PDIF INPUT and OUTPUT43
- Speaker Output43
- Kensington® Lock Connector43
Front Panel Controls Stage44
- On/Off Button45
- Mode Select Buttons45
- INPUT Button45
- Input Led47
- Module and Section Buttons48
- OUTPUT/MASTER Button48
- Output Led49
- MASTER VOLUME Knob49
- SYSTEM Button50
- PEDALS Button50
- RIG Button50
- TYPE Knob50
- BROWSE Knob51
- Soft Buttons and Soft Knobs51
- MORPH Button51
- LOCK Button52
- EDIT Button52
- COPY and PASTE Buttons (N/A)53
- STORE Button53
  - Button54
- PAGE> Buttons54
- GAIN Knob54
- Up/Down Buttons55
- Rig Buttons55
- TAP Button55
- TUNER Button56
- Effect Buttons I-IIII56
- Looper56
Back Panel Overview Stage58
- Input58
- Return58
- Send 1+259
- Main Output59
- Monitor Output60
- HEADPHONE Output60
- S/PDIF INPUT and OUTPUT61
- Switch/Pedal61
- MIDI61
- Usb62
- Kensington® Lock Connector62
- Power62
Basic Setups63
Using the Tuner65
Rig Settings67
- Tagging67
- Favorites69
- Rig Spillover off69
- Snapshots69
- Panorama70
- Transpose70
- DLY+REV Routing70
- Rig Volume70
- Tempo72
- Volume Pedal74
- Parallel Path75
- Morph77
Working with Amplifier Profiles, Cabinet Profiles, Power Amps and Guitar Cabinets78
- Separating Amps and Cabinets: Cabdriver78
- Browsing Amps or Cabinets79
- Direct Profiles80
- Direct Amp Profiles82
- Cabinet Impulse Responses83
- Merging Studio Profiles and Direct Amp Profiles83
- Running a Guitar Speaker Cabinet from a Power Amplifier, "Monitor Cab off86
- The Built-In Power Amplifier89
- The Sound of Guitar Cabinets Versus MIC'ed Speakers92
- Pure Cabinet94
KEMPER Kone / KEMPER Kabinet95
- Using KEMPER Kone with PROFILER Powerhead or Powerrack99
- KEMPER Kone Wiring101
Output Section102
- Output Volumes and Output Volume Link102
- Output Sources104
- Main Output113
- Monitor Output113
- Output Equalizers114
- Output Filters114
- Space114
- Auxiliary Input115
- Constant Latency118
Instrument Input and Reamping119
- Input Source Select119
- Reamping121
  - Alternative Procedure for Input Leveling125
Expression Pedals and Foot Switches126
- Pedal Controllers126
- Expression Pedal Recommendation128
- Connecting Pedals to PROFILER Remote or PROFILER Stage129
- Additional Switches Required134
  - Connecting a PROFILER Switch135
  - Single and Dual Switches of Other Brands135
- Connecting Pedals and Switches to PROFILER Head, Powerhead, Rack or Powerrack136
- Volume Pedal Function138
- Morphing139
- Monitor Volume Pedal (MIDI Control Change #73)143
Stack Section144
- Amplifier144
- Cabinet149
Effects151
Wah Effects (Orange)154
- Wah Parameters156
Distortion (Red)159
Booster (Red)161
Shaper (Red)162
- Bit Shaper163
- Recti Shaper163
Equalizer (Yellow)164
- Graphic Equalizer164
- Studio Equalizer164
- Metal Equalizer165
- Acoustic Simulator165
- Stereo Widener167
- Phase Widener167
- Delay Widener167
Compressor (Cyan)169
- Auto Swell170
Noise Gate (Cyan)171
- Noise Gate 4:1171
Chorus (Blue)172
- Vintage Chorus172
- Hyper Chorus173
- Air Chorus174
- Micro Pitch175
- Vibrato176
- Rotary Speaker176
- Tremolo / Auto Panner179
Phaser and Flanger (Purple)180
- Phaser180
- Vibe Phaser182
- Flanger182
- Phaser Oneway & Flanger Oneway182
Pitch Shifter (White)183
- Transpose184
- Pedal Pitch185
- Pedal Vinyl Stop186
- Chromatic Pitch186
- Harmonic Pitch188
- Analog Octaver192
Delay (Green)194
- Single Delay202
- Two Tap Delay203
- Serial Two Tap Delay204
- Dual Delay205
- Rhythm Delay206
- Quad Delay208
- Legacy Delay209
Pitch Shifter Delay (Light Green)210
- Chromatic Type210
- Harmonic Type210
- Loop Pitch Type210
- Crystal Type211
- Crystal Delay211
- Loop Pitch Delay212
- Frequency Shifter Delay213
- Dual Chromatic Delay & Dual Harmonic Delay214
- Dual Crystal Delay215
- Dual Loop Pitch Delay216
- Melody Delay217
- Quad Chromatic Delay & Quad Harmonic Delay218
Reverb (Green)219
- Spring Reverb219
- Natural Reverb221
- Easy Reverb226
- Echo Reverb226
- Cirrus Reverb227
- Formant Reverb228
- Ionosphere Reverb229
- DLY and REV Modules230
- Space234
- Legacy Reverb234
Effect Loop (Pink)235
System Settings239
- LCD / HW Setup / Brightness / User Interface239
- User Interface 2241
- Audio Setup242
- Pedal Links243
- Pedal243
- Remote Settings243
- MIDI Program Change Assignments and Settings244
- Date and Time244
- Device Information245
Bass Players: Special Hints and Features246
Performance Mode248
- Loading Performances250
- Foot Control250
PROFILER Remote251
- Up/Down Buttons252
- Rig Buttons252
- TAP Button252
- TUNER Button253
- Effect Buttons I-IIII253
- LOOPER Button257
  - Workflow260
  - Advanced Looper Functions262
- Connecting Expression Pedals and External Switches263
- Remote Settings263
- Cabling264
MIDI267
- Continuous Controllers268
- Effect Switches269
- Rig Change in Performance Mode271
- Rig Change in Browser Mode274
- MIDI Global Channel275
- MIDI Clock275
- Transmitting MIDI Commands to Two External Devices in Performance Mode276
- Transmitting Pedal Controllers for Morphing, Wah, Volume, and Pitch to Two External Devices276
- Transmitting User Interface to MIDI Global Channel277
- Nrpn277
Getting Organized278
- Views278
- Favorite Rigs279
- Erase Non-Favorites280
- KEMPER Rig Manager280
Updates, Backups and Sharing Sounds281
- Operating System Updates281
- Creating Backups283
- Restoring Backups283
- Importing Rigs, Performances, and Presets284
- Export of Rigs and Presets284
Screen Symbols286
PROFILING an Amp287
- General Considerations287
- Making Connections290
- Taking a PROFILE294
- How to PROFILE an Amp Without a Cabinet (Direct Amp Profiles)299
- How to Create Merged Profiles302
- PROFILING a Rotary Speaker Cabinet304
- Under the Hood305
Trouble Shooting306
- Customer Support308
Technical Specifications309

Other manuals for Kemper PROFILER

Quick Start132 pages

The Basics & Profiling Guide144 pages

Related product manuals

Preview: Kemper PROFILER Stage

Kemper PROFILER Stage

Preview: Kemper PROFILER Remote

Kemper PROFILER Remote

Preview: Kemper Profiling Amp

Kemper Profiling Amp

Preview: Kemper Profiling Amplifier

Kemper Profiling Amplifier