KEMPER Kone / KEMPER Kabinet 97
✓ The Speaker Imprint and Directivity parameters are only available in Speaker Imprint mode, when Monitor Cab Off is
active. However, Bass Boost is available in both modes.
Here are some additional properties of the KEMPER Kone:
• The KEMPER Kone comes either built-in into our KEMPER Kabinet™, or as a replacement speaker-fitting in any
1x12, 2x12 or 4x12 cabinet designed for 12-inch speakers, either open or closed.
• The impedance of the KEMPER Kone is just 4 Ohm, to get optimal efficiency from your power amp. Since 4 Ohm is
usually the lowest impedance allowed for power amps, you should avoid undercutting this value by connecting two
cabinets, or two speakers in parallel configuration, to the same power amp output. If two KEMPER Kone speakers
are mounted in a 2x12 cabinet, they must be wired in series.
• Two or more KEMPER Kabinets can be safely daisy-chained by the additional jack, as the built-in circuitry has been
designed to run multiple Kabinets in series automatically.
✓ The KEMPER Kone speaker and KEMPER Kone mode in the PROFILER are a perfect match. Therefore, please do
not run the KEMPER Kone without the KEMPER Kone mode activated. You should also refrain from running the
KEMPER Kone speaker with any sound generator other than the PROFILER. If you do, it will not sound good, and
will certainly not sound as intended. The same applies for running the KEMPER Kone mode into another speaker —
this will also not sound good.
✓ Any solid-state amp will work. Using a tube power-amp will change the frequency response and potentially sweeten
the sound too much.
✓ Like the Monitor Cab Off feature, the KEMPER Kone mode is only available for the MONITOR OUTPUT, as well as
for the built-in power amp, and is dedicated to your personal monitoring. The other outputs are not affected by these
features.
✓ Due to its special cone design, the KEMPER Kone speaker is not suitable for close mic‘ing. Use it for personal
monitoring only.
To Next Page
