Kemppi 25 - Product Introduction; Operation Safety

EN
1.2 PRODUCT INTRODUCTION
Kemppi PMT MIG/MAG guns for manual welding are designed for demanding
professional use. They are suitable to be used in all MIG units equipped with
a Euro adapter.
1.3 OPERATION SAFETY
Please study these Operation safety instructions and respect them when
installing, operating and servicing the machine.
Welding arc and spatters
The welding arc hurts unprotected eyes. Also be careful with reecting arc
ashes. The welding arc and spatter burn unprotected skin. Use safety gloves
and protective clothing.
Danger of re or explosion
Pay attention to re safety regulations. Remove ammable or explosive
materials from the welding location. Always reserve sucient re-ghting
equipment at the welding location. Be prepared for hazards in special
welding jobs, e.g. the danger of re or explosion when welding container
type work pieces.
NOTE! Fire can break out from sparks even several hours after welding has been
nished!
Mains voltage
Never take the welding machine inside a work piece (e.g. container or truck).
Do not place the welding machine on a wet surface. Always check cables
before operating the machine. Change damaged cables without delay.
Damaged cables may cause injury or start a re. Connection cable must not
be compressed or touch sharp edges or hot work pieces.
Welding power circuit
Isolate yourself by using proper protective clothing, do not wear wet
clothing. Never work on a wet surface or use damaged cables. Do not put
the MIG gun or welding cables on the welding machine or on other electric
equipment. Do not press MIG gun switch, if the gun is not directed towards a
work piece.
Welding fumes
Make sure that there is sucient ventilation during welding. Take special
safety precautions when welding metals which contain lead, cadmium, zinc,
mercury or beryllium.
4
PMT © Kemppi Oy / 1130