EN
• Press the cover of the plastic protection back in place. Make sure that
the cooling liquid hoses and their bending protections are placed inside
plastic protection without any sharp bends and make that they retain
the original shape of the hose.
• Tighten the screws of the cover.
• Mark the sticker on the cover to signify that the connection has been
changed into the position “FU”.
• The gun is now ready for use in devices other than Promig or Feed, e.g. in
FU wire feeders of Multisystems.
You can use the PMT gun with the FU connection also with the Promig and
Feed but control and thermal protection operations will not be available.
7
PMT © Kemppi Oy / 1130
To Next Page
Loading...
