EasyManuals Logo

Kemppi Adaptive 180 User Manual

Kemppi Adaptive 180
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
EN
NOTE! When driving the wire in to the gun, do not point the gun at yourself or
others or put, for example, your hand in front of the tip, because the cut wire end
is extremely sharp. Also, do not put your ngers near the feed rolls, because they
might get squeezed between the rolls.
2.5.3 Reversing polarity
Some ller wires are recommended to be welded with the gun in the –pole,
so the polarity should be reversed. Check the recommended polarity from
the ller wire package.
1. Disconnect the machine from the mains.
2. Bend the rubber cover of the earthing cable’s pole in such way that the
cable can be disconnected.
3. Remove poles tightening nuts and washers. Note the correct order of
the washers!
4. Interchange the cables.
5. Install the washers in place and close the tightening nuts to spanner
tightness.
6. Put the rubber cover of the earthing cable’s pole rmly in place. The
rubber cover must always protect the earthing cable’s pole.
11
MinarcMig 180 / © Kemppi Oy / 1117

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kemppi Adaptive 180 and is the answer not in the manual?

Kemppi Adaptive 180 Specifications

General IconGeneral
BrandKemppi
ModelAdaptive 180
CategoryWelding System
LanguageEnglish

Related product manuals