EN
2. MACHINE USE
The machine is delivered ready for operation without adjustments with
0.8 mm diameter ller wire.
If you use dierent thickness ller wire, make sure that the feed roll groove,
welding gun contact tip and machine polarity are suited for the used
wire size and type. If you mainly use aluminium or stainless steel wire, we
recommend you change the wire guide to a plastic one which is better suited
for the wire type.
2.1 BEFORE IMPLEMENTATION
The products are packed to durable packages especially designed for them.
However, always make sure before use that the products have not been
damaged during transportation. Check also, that you have received the
products you ordered and the instruction manuals needed. Product packing
material is recyclable.
Transportation
The machine should be transported in an upright position.
NOTE! Always move the welding machine by lifting it from the handle. Never pull
it from the welding gun or other cables.
Environment
The machine is suitable for both indoor and outdoor use, but it should be
protected from heavy rain and sunshine. Store the machine in a dry and clean
environment and protect it from sand and dust during use and storage. The
recommended operating temperature range is -20° C – +40° C.
Place the machine in such a way that it does not come in contact with hot
surfaces, sparks and spatters.
Make sure the air ow in the machine is unrestricted.
5
MinarcMig 180 / © Kemppi Oy / 1117
To Next Page
Loading...
Need help?
General
