Kemppi KMS 400 AS - Positioning and Location of the Machine; Connecting Cables; Water Cooled System: Fastmig KMS as + MSF;MXF + Fastcool 10 + Arcfeed

EN
POSITIONING AND LOCATION OF THE MACHINE3.3
Place the machine on a rm, dry and level surface. Where possible, do not allow dust or other
impurities to enter the machines cooling air ow. Preferably site the machine above oor level;
for example on a suitable carriage unit.
Notes for positioning the machine
The surface inclination should not exceed 15 degrees.•
Ensure the free circulation of the cooling air. There must be at least 20 cm of free space in •
front of and behind the machine for cooling air to circulate.
Protect the machine against heavy rain and direct sunshine.•
NOTE! The machine should not be operated in the rain as the protection class of the machine,
IP23S, allows for outside preserving and storage only.
NOTE! Never aim metallic grinding spray/sparks towards the equipment.
CONNECTING CABLES3.4
NOTE! Always check before use that the interconnecting cable, shielding gas hose, earth return
lead/clamp, and mains cable is in a serviceable condition. Ensure that connectors are correctly
fastened. Lose connectors can impair welding performance and damage connectors.
Water cooled system: FastMig KMS AS + MSF/MXF + FastCool 10 + ArcFeed3.4.1
GND
7
FastMig KMS 400 AS / © Kemppi Oy / 1021